VINGLI Swimming Pool Vacuum Cleaner Automatic Sweeper, Automatic Suction Vacuum with Ten Hoses and Two Yellow Diaphragms, Blue

Product Description

Clean area note

In order to peotect vacuum . the cleaner can work on curved surfaces but do not clean the stair on the pool.

Cleaning type

The pool vacuum can clean algae . dirt and dust but can not clean leaves.

Underwater work

Just drop into the base of pool and the max deep is 9.8ft.

Product specification

Vacuum head . blue skirt and hose size display.

Accessories display

Comes with ten hoses . two weight . one regulating VALVES . diaphragm.

If the hose is too long or too short . you can increase or reduce hose.

Hose diameter

Each hose diameter is 1.96 inch.

There a special hose which need to connect to pool vacuum . and other hose neen to connect with that.

Ten hoses

Come with 10 hoses total 33 ft . each hose is 3.3ft.

White little weight function

White little weight can keep balance when you clean the pool and seal the hose.

Blue disc installation

Need to install the blue disc counterclockwis

No air in hoses

In order to get great usage effect . should be no air in hoses before using. Make sure the hoses in no leak and the pressure is normal.

Diaphragm

The diaphragm is silent and service life is 200 hours.

NOTE:

1.If the vacuum doesn't work . please check diaphragm especially of the diaphragm mouth inside see if there is a gap inside and check if any small rock stuck in the diaphragm.

2.If suction is too large or small . need to adjust the regulating VALVES.

3.If vacuum stop work when it reaches the surface of the pool .you need to adjsut regulating VALVES and adjust suction lower.

Problem: Cleaner is sluggish or has stopped operating.

Solution:

● Check if the pump is ON and / or primed.

● Check Cleaner head for blockages.

● Clean and empty pump basket and empty skimmer/weir basket.

● Ensure the filtration system is thoroughly cleaned. Clean sand/cartridge filters on your pool pump as per manufacturers specifications.

● Inspect the regulator VALVES and flush away any debris build-up.

● Check the Mat for wear.

● Make sure the curved tips of the Mat are facing upwards.

● Ensure that the skimmer/weir vacuum lid is fitted correctly and check for cracks.

● Check the hose for blockage.

● Check the hose for leaks by lifting each section above water while pump is running.

● Consult a pool shop in your area.

Problem: Cleaner travels in a repetitive pattern.

Solution:

● Adjust return jets downwards.

● Verify proper hose length.

● Ensure cleaner sits flush with the pool floor. Adjust the position of hose weight if necessary.

● This should be done at the deepest part of the pool.

● Remove or add one hose section.

● Inspect the Regulator VALVES and flush away any debris build-up. ● Check that the hose sections are straight; if not . lay hose in a straight line in the sun to relax the memory.

● Twists each hose section a half-turn at each connection point.